Electrical Transport — Hybrid metal-organic chalcogenide nanowires with electrically conductive inorganic core through diamondoid-directed assembly

2 measurement groups · 8 results

Reported values remain attached to the sample, method, conditions, extraction quality and source location that produced them.

H2O2-doped 1ADCu powder samples · Powder

About 20 mg dry powders in quartz tube with 15 mm inner diameter and gold-plated stainless-steel disk electrodes; 1 Hz to 1 MHz.

Temperature: room temperature
Geometry: Randomly oriented powder between gold-plated stainless-steel disk electrodes.
Context: H2O2-doped 1ADCu powder series.
Measurement source: SI p.15 · Supplementary figures · Fig. S10

Property	Reported value	Normalised value	Uncertainty	Origin and quality	Source
Relative resistivity of 1ADCu after 10000 ppm H2O2	about 1.5e-3 from Fig. 5h	—	—	Visual Estimate Approximate	main p.5, article p.353 · Doping and transport · Fig. 5h
Relative resistivity of 1ADCu after 100 ppm H2O2	about 6e-3 from Fig. 5h	—	—	Visual Estimate Approximate	main p.5, article p.353 · Doping and transport · Fig. 5h
Relative resistivity of 1ADCu after 10 ppm H2O2	about 2e-1 from Fig. 5h	—	—	Visual Estimate Approximate	main p.5, article p.353 · Doping and transport · Fig. 5h
Maximum 1ADCu resistivity decrease with H2O2 doping before lattice disruptionMarked as a best value within this paper	approximately three orders of magnitude decrease up to 10^4 ppm H2O2	—	—	Text Approximate	main p.6, article p.354 · Doping and transport · Fig. 5h; Fig. S10

Vertically aligned 1ADCu crystal array embedded in AAO · Electrode

SP-200 Bio-Logic impedance analyser, 50 mV peak-to-peak bias, frequency range 1 Hz to 1 MHz; equivalent circuit fit.

Temperature: room temperature
Geometry: MOC-embedded AAO membrane with 5 nm Ti/200 nm Au electrodes on both sides; axial transport along vertical array.
Context: Composite device containing pristine MOC nanowires/nanoribbons in AAO; resistivity corrected for 0.03% filling ratio.
Measurement source: main p.5 and Methods · Electronic transport; Characterizations · Fig. 5g

Property	Reported value	Normalised value	Uncertainty	Origin and quality	Source
1ADCu axial resistivityMarked as a best value within this paper	about 100 ohm m	100 ohm m	—	Text Approximate	main p.6, article p.354 · Electronic transport · Fig. 5g
1ADCu fitted MOC resistance RMOC	0.3 Mohm	300000 ohm	—	Text Exact Reported	main p.6, article p.354 · Electronic transport · Fig. 5g
4DICu axial resistivity	about 300 ohm m	300 ohm m	—	Text Approximate	main p.6, article p.354 · Electronic transport · Fig. 5g
MOC filling ratio in AAO used for resistivity calculation	about 0.03%	0.0003 fraction	—	Text Approximate	main Methods page · Characterizations